I have disabled the on-oard audio devices, so that only the USB Codec device (which is the interface) is active and set both input and output sampling to 48K Hz (have also tried 41K). I also frequently hear a faint popping sound during setup. However, the audio in the solo session is either really bad, with lots of noise and odd sounds, plus I see lots of output jitter - but the latency is good (under 5), OR the sound is very intermittent, meaning I can tap one of the drums and only 1 note out ten come thru. Occasionally, for reasons I do NOT understand, it does pass the I/O part too and I am able to add that audio gear setup and then open a solo session. on initial setup, it can't determine latency and I have to go to loopback Test page, where (when the test works at all) latency is around 3-4ms, but I/O usually fails test and I can't proceed. On my numerous attempts to setup my Audio Gear in JamKazam, I have never been able to get it to work cleanly when I select ASIO4ALL. I was dismayed when I found out the driver I had to use was ASIO4ALL, as that is what JamKazam says NOT to use, but it's what Behringer pointed me to, so I downloaded an installed it - see attachment for latest settings used. BTW running on Lenovo laptop w/ Windows 10. I bought the Behringer UM2 interface, since I really only needed the one port for input from my Roland TD-15, which I run thru a Mackie 1402 (along with a condenser mic for chat) and into the UM2.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |